You have no items in your shopping basket.
Product Description
The A-10 Thunderbolt II (also known as the Warthog) is an American single-seat, twin-engine, straight-wing jet aircraft designed to provide close air support of ground forces. It was the first USAF aircraft designed exclusively for close air support.
The A-10 has superb manoeuverability even at low speeds and altitude, this is due to its large wing area, high wing aspect ratio, and large ailerons. This design also enables short takeoffs and landings, allowing it top operate from the smallest and most basic airfields.
This model replica of the A-10 Thunderbolt II is 90% assembled, so you can get it in the air within minutes of opening the box. Once assembled this plane looks amazing and quite imposing with a wingspan of nearly three feet!
When it is airbourne it has full four channel radio control, allowing adjustment of the aileron, elevator, throttle, and when the plane is on the ground, it is complete with front wheel steering!
Powered by twin gutsy 2410-size brushless motors(1200KV) this plane is capable of high speed, 3D aerobatic stunts and also is able to fly in blustery conditions. The A-10 is a confident acrobat and capable of a full range of impressive tricks and manoeuvres in experienced hands. It can perform: inside loops, outside loops, axial rolls, inverted flight, knife edge, stall turns, hammerheads, and spins.
Despite its aerobatic pedigree, the same design that gives it the ability to carryout breathtaking 3D moves, means it is a stable plane and so also suitable for the beginner and mid-level pilot too.
The Thunderbolt has been specified by Nitrotek with a powerful brushless motor, and a 2.4Ghz radio transmitter, making it a perfect choice for the enthuiast. We have also upgraded the charger from a standard one, to a balanced charger included in the price. This makes charging safer and better for the battery.
Specs
Wing span: 872mm
Length: 968mm
Flying Weight: 450g
Drive: Twin brushless motors 1200KV
Speed Controller: 25A brushless ESC
Servo: 3x10g
Battery: 11.1V 15C 1500MAH Li-Po
Charger: Li-Po balance charger
Control: 4 CH Radio Tx and Rx
Range: 1000 feet
Features
4 CH Full RC - Aileron, Elevator, Wheel, Throttle
Full aerobatic characteristics
Powerful brushless motors
Excellent stability
Ready to Fly in Just Minutes!
Super tough & Lightweight
Shock Resistant Fuselage
Pre-installed Electronics
Suitable for beginners and experts
Only required 8 AA batteries for the transmitter to start flying
10-15 minutes flight time
This plane is described as RTF or ready to fly, this means that everything except batteries for the transmitter is included in the box and that only a few minor stages of assembly remain, such as attaching the wings and tailplane. These steps should take around 30 minutes to complete.
The A-10 has superb manoeuverability even at low speeds and altitude, this is due to its large wing area, high wing aspect ratio, and large ailerons. This design also enables short takeoffs and landings, allowing it top operate from the smallest and most basic airfields.
This model replica of the A-10 Thunderbolt II is 90% assembled, so you can get it in the air within minutes of opening the box. Once assembled this plane looks amazing and quite imposing with a wingspan of nearly three feet!
When it is airbourne it has full four channel radio control, allowing adjustment of the aileron, elevator, throttle, and when the plane is on the ground, it is complete with front wheel steering!
Powered by twin gutsy 2410-size brushless motors(1200KV) this plane is capable of high speed, 3D aerobatic stunts and also is able to fly in blustery conditions. The A-10 is a confident acrobat and capable of a full range of impressive tricks and manoeuvres in experienced hands. It can perform: inside loops, outside loops, axial rolls, inverted flight, knife edge, stall turns, hammerheads, and spins.
Despite its aerobatic pedigree, the same design that gives it the ability to carryout breathtaking 3D moves, means it is a stable plane and so also suitable for the beginner and mid-level pilot too.
The Thunderbolt has been specified by Nitrotek with a powerful brushless motor, and a 2.4Ghz radio transmitter, making it a perfect choice for the enthuiast. We have also upgraded the charger from a standard one, to a balanced charger included in the price. This makes charging safer and better for the battery.
Specs
Wing span: 872mm
Length: 968mm
Flying Weight: 450g
Drive: Twin brushless motors 1200KV
Speed Controller: 25A brushless ESC
Servo: 3x10g
Battery: 11.1V 15C 1500MAH Li-Po
Charger: Li-Po balance charger
Control: 4 CH Radio Tx and Rx
Range: 1000 feet
Features
4 CH Full RC - Aileron, Elevator, Wheel, Throttle
Full aerobatic characteristics
Powerful brushless motors
Excellent stability
Ready to Fly in Just Minutes!
Super tough & Lightweight
Shock Resistant Fuselage
Pre-installed Electronics
Suitable for beginners and experts
Only required 8 AA batteries for the transmitter to start flying
10-15 minutes flight time
This plane is described as RTF or ready to fly, this means that everything except batteries for the transmitter is included in the box and that only a few minor stages of assembly remain, such as attaching the wings and tailplane. These steps should take around 30 minutes to complete.
